Basics and tips
A cutting edge is comprised of the intersection of two planes to form an edge. The angle formed by these two planes is the bevel
angle. Sharpening is the removal of material from a bevel face to keep a well-defined edge. Sharp tools are essential to everyone and
maintaining a sharp edge allows for a safer easier working environment.
Keeping a sharp edge on your tools is quick and simple when using a DMT Diamond sharpener, whether bench stone or pocket
models, interrupted diamond surface or continuous. The diamonds remove material from the edge as it slides across the sharpener.
You can use your DMT stone dry or with water; as you sharpen, metal fines will accumulate on the sharpening surface so you should
thoroughly wash the surface and dry after using.
Be sure you have cleaned your edge, whether knife, blade, pruner, chisel, etc., before sharpening.
Different DMT surfaces
The interrupted, or polka dot pattern is extremely efficient as the recessed holes collect metal fines to prevent loading. The
continuous diamond surfaced stone (Dia-Sharp®) is slightly less aggressive, but as effective in sharpening. Selection is a personal
preference.
It will only take a few quick strokes of your edge on the DMT sharpener when you notice your edge starts to dull and you will never be
without a keen edge.
If you maintain your edges, a fine diamond stone will be all you need. Extra-extra coarse stones are reserved for extreme stock
removal and repair, otherwise, if an edge is damaged, start with an extra-coarse stone; if an edge is neglected, start with a coarse
stone. To finish sharpening, step through the next grit from the starting grit and finish with a fine diamond stone. If you want a more
polished edge, after using a fine diamond, complete with an extra-fine stone and if you want a more refined edge, step through to
extra-extra fine.
Do not over sharpen. About 30 strokes on a conventional sharpening stone is equivalent to about 5 or 6 strokes on a DMT sharpener.
This will save you time and extend the life of your tool. As noted above, you can also repair lost edges or nicks by starting with
coarser grit sizes and stepping down as the edge gets sharper. Match the bevel with the sharpener to maintain your edge. Even
more important than matching the bevel however is to keep a constant angle so you have a consistent edge.
Break-in Period
Initially, the diamond surface will seem aggressive in nature; the diamond sharpener will smooth after initial sharpening with no impact
to long term performance.
Overview
Sharpening = removal of material.
Sharpening keeps tools safer and easier to use.
Interrupted diamond surface vs. continuous diamond surface - personal preference.
Start with larger grit sizes then step down to refine your edge.
Match bevel angle (but MORE IMPORTANT keep angle constant).
Do not over sharpen.
Initial sharpening = break-in period
Cleaning and Maintenance
Cleaning and care of a DMT®
stone is simple and necessary for best performance. After using a DMT Diamond Bench Stone or
Sharpener simply wet it (if it is not already lubricated with water) and wipe the slurry off with a rag. This slurry is evidence that the
sharpener has done its job. If the swarf is not wiped off the sharpener after use it may clog up the diamond and not allow it to sharpen
as well as it could were it clean.
Also, once in a while it is a good idea to get a common cleanser and scrub the sharpener with a nylon brush or nylon pad. This will
ensure the sharpener is not clogged with slurry and will allow for optimal sharpening. Finally, make sure you store your sharpeners
dry after you clean them off.
Overview
Clean off with rag after use
Not cleaning will result in clogging
Scrub with cleaner periodically
Store dry
Lorem Ipsum is simply dummy text of the printing and typesetting industry. Lorem Ipsum has been the industry's standard dummy text ever since the 1500s, when an unknown printer took a galley of type and scrambled it to make a type specimen book.
- Availability: In Stock
- Product Code: 11053